These are easy peasy if you know how to make a simple ribbon browband.
Plain ribbon browband
4 meters of Ribbon (velvet is more popular in this design)
1-3mm wrapping cord
Rhinestone/ crystal banding (about 30cm long & width to match browband)
Glue (i use Tarzan's grip)
material for flag & rosette bases (i use plastic)
1. Glue your backing ribbon to the back of your browband. wrap the ribbon around the browband until it is covered (do not go over the loops). Alternatively some people use the sharkstooth design.Glue down the end when you finish and cut off excess.
2. Glue your rhinestone/ crystal banding to the front to the browband. Make sure it covers the length you have ribboned.
3. Glue the wrapping cord to the back of your browband and wrap between the rows of crystals.
You can use a few colours if you like.
Once you have finished the length of the browband glue the cord down (at the back) and cut excess. I like to had a small piece of ribbon glued at either end over the top of the cord to secure it a little better.
4. make your rosettes and flags (not going into detailed instructions).
If you have rings i find the easiest way to add them is to glue them on. if the have a bar remove them with pliers. One you have finished your flags and rosettes glue them on. The flags go on first, cover any of the browband that is exposed. Glue the rosettes on top of them.
(blindingness of bling browband!)
I hope that gives every one an idea of how to make them. They are very very simple to make, easier then most regular ribbon browbands.
I have been thinking of making a guide for them with step by step pictures but some one beat me to it. You can buy the guide on ebay or at http://exclusivdesigns.com/